|Working life||5 years||Voltage||DC12v|
|Color||black||Application||automotive heating equipment|
After the heater starts, the glow plug comes into operation, the magnetic pump begins to supply fuel, combustion-supporting fan inhales combustion-supporting air from outside of car. The fuel generates the heat by burning in combustion chamber, which is taken by aluminum heat exchanger. The inner air pushed by the heat exchange fan brings heat to where it is needed through the surface of heat exchanger. And the combustion emission is discharged through exhaust pip.
Only special-purpose parts can be used for installation of the heater. Following picture is the diagram for installation. The positions and ways of fixing of various parts may vary from one automobile model to another, but the general principles must be followed in conformity with the requirements of this chapter. Otherwise the heater may not work normally or safety problems my occur. The main heater could be installed both inside and outside of the vehicle. If the heater is installed outside the vehicle, measures must be taken to avoid splashing water onto the heater. Enough space must be provided for installation for the convenience of heating air flow and installation,maintenance of the main heater.
Good sealing is necessary between the main heater and the installation surface on the vehicle.The special gasket supplied by the manufacturer must inserted in.And the installation surface must be even.Its parts at the installation bases of the main heater should have uneveness less than1mm.After drilling installation holes, eveness must be improved according to this requirement.At installation, please rotate the four M6 nuts tight, which are provided by the manufacturer. For re-installation of the main heater, a new gasket must be used to replace the old one.
Manual adjustment of power percentage；Automatic adjustment of constant temperature ；Manual Switch: Manual program opening.
（2）Automatic switch:Automatic program opening.
（3）Power off : turn off the heater.
（5）Fahrenheit: display Fahrenhei.
（6）Centigrade: display Centigrade.
（7）Current temperature (current air inlet temperature); Power percentage on manual mode；Constant temperature setted on automatic mode.
（8） Mode:Working mode displaying