The New Digital Controller For 2kw And 5KW Air Diesel Parking Heater

- Dec 26, 2017-

图片1.png

1.Button descriptions

(Air conditioning button空调): Long press the air conditioning button to start the air conditioning mode during the standby state. Under this state the heater will automatically modulate its gear according to the preset temperature. With the main body working, long press to shut down the heater.

(Manual button手动)Long press the manual button to carry out the manual mode during the standby state. Please note that during this state the user needs to modulate the gears on his or her own. Long press the manual button to shut down the heater.

(Code programmer)

 Rotate clockwise to raise gears during the manual mode and rotate anti-clockwise to lower gears with the range of 1-5 gears.

Rotate clockwise to increase the preset temperature during the air conditioning mode and rotate anti-clockwise to reduce the preset temperature. The temperature ranges from 15 degrees to 32 degrees.

2. Display Descriptions

1.)During the manual working mode, there will be the mark of heating and meanwhile the indicative light of the code programmer gives solid light. At this time rotate the code programmer and there will be the twinkling display of the target gear on the LCD screen. With no operation for 5 seconds, the screen will come back to the temperature display. With no operation of 10 seconds, the backlight will turn off automatically. Press any button to check the parameters if needed. When the screen shows F, rotate the code programmer to check the corresponding parameters of the heater(the power of glow plug, the voltage of the battery, the rotational speed of the blower motor, the current temperature and so on)

2.) The screen will display the mark of the fan and the indicative light of the code programmer gives solid light during the air conditioning mode. Rotate the code programmer to view the twinkling display of the modulated preset temperature. With no operation of 5 seconds, the screen will lurch back to the display of the current temperature. With no operation of 10 seconds, the backlight turn off automatically. Press any button to check the parameters if needed. When the screen shows F, rotate the code programmer to check the corresponding parameters(the power of the glow plug, the voltage of the battery, the rotational speed of the blower motor, the current temperature and so on)

3). Rotate the code programmer to come directly into the switch of the parameter viewing during the standby state.

4).Error code display: the error code twinkles on the screen and there are red lights twinkling in the code programmer.

3. Special functions

After the first installation, the heater needs to pump the fuel. Press both the manual button and air conditioning button for five times. 1.5 seconds later, start the function of pumping fuel. If needed to stop, press any key to stop pumping fuel.