Face Automatic Thermometer In Shop

Face automatic thermometer in shop Product introduction JNF-W7K is a high-performance dynamic temperature-measuring face recognition terminal, which is divided into gate installation and wall installation.The terminal integrates the functions of off-line face recognition, temperature detection,...
Chat Now

Product Details

Face automatic thermometer in shop

Product introduction

JNF-W7K is a high-performance dynamic temperature-measuring face recognition terminal, which is divided into gate installation and wall installation.The terminal integrates the functions of off-line face recognition, temperature detection, mask recognition, identity verification, on-site face collection, blacklist early-warning, photo taken after passing, active object detection. It adopts WDR HD face recognition camera, which is fully adapted to harsh environment such as strong light, back light and weak light, with characteristics of fast recognition speed, high accuracy and large list storage capacity. It can be used with application management systems such as face-based site real-name management system, face-based access control attendance management system and visitor management system, which is perfect for complex application scenarios that require temperature monitoring, identity recognition and access control, such as communities, campuses, hospitals, scenic spots, hotels, shopping malls, office buildings, public places and construction sites. In terms of epidemic prevention and control, it effectively reduces the potential risks of large-area contact with human body during temperature measurement, shortens the temperature measurement time and improves the temperature measurement efficiency. At the same time, centralized management provides real-time data support for the screening and tracing of suspected patients and floating population, and provides a strong safety guarantee for the management under the above scenarios. 


图片1.png
4261593398961_.pic.jpg
4271593399054_.pic.jpg


Installation diagram of gate type

Before installation, it is necessary to comprehensively consider factors such as the height of the crowd on the site and the environmental conditions, and choose appropriate opening position, which generally located in the middle or front of the gate. Reference opening position is shown in the following figure:

When the gate is equipped with a card swiping (ID / IC card / ID card) module, the opening of the face terminal device shall be installed as far away from the card swiping module as possible considering the height of the gate. It is recommended to adopt 400mm and above interval to ensure clear and complete face photos when swiping. There is no special requirement for the position of mounting holes if no card swiping module is required.

During installation, unscrew the nuts under the device leg, pass the cable through the nut and gasket, and remove the nut and gasket (Note: Do not connect the network cable, power cord, etc. for the convenience of installation).

At the bottom of the gate, pass the tail circuit through the gasket and nut successively, and tighten the nut on the thread; connect the power supply and network cable. Hold the leg with both hands and turn it gently to adjust the gate angle, and adjust the gate head to an appropriate recognition angle according to the recognition effect.



Hot Tags: face automatic thermometer in shop

Inquiry

You Might Also Like